The ACCU Long Range precision rifle cheek riser will give you the proper cheek weld for mounted optics. It’s perfect for precision target shooting, long range hunting and snap shooting with your rifle.
Our cheek risers are FDM 3d printed manufactured. Due to the innovative geometric internal structure from this process, our cheek risers are made with a huge strength to weight ratio. Our rifle cheek risers are black in colour and are available in the following heights to 13mm, 16mm and 18mm. These cheek risers are designed to be setup and have the front section slide away to allow you to install/remove your bolt and allow for cleaning. This allows you to keep the main section of the cheek riser in the perfect resting check position since there isn’t a need to remove the cheek riser for bolt installation and removal.
The following heights are available: (Version 2): 13mm, 16mm, 18mm.
The photo’s illustrate the cheek rest on a Tikka T3. However, they will fit a wide array of stocks including Tikka TX3, Sako, Remington, Marlin. I’ve even added them to Choate and ATI fiberforce 10/22. Feel free to get in contact with us regarding stock fitting.
Our cheeks risers have helped many people around the world overcome the problem of establishing a good stable cheek comb height. This is especially a problem when using scopes or other optics with bolt action rifles. Most bolt action rifles still have the comb height designed for open sights. When adding optics, it rises the stock comb height requirement by roughly 13mm to 18mm. To solve the cheek resting in the proper position requires a cheek riser. However, the added cheek riser, can get in the way of installing and removing the bolt in a bolt action rifle.
We have created a solution by producing a cheek riser, with the ability to remove the front section. This is so that you can install and remove the bolt from the action of your rifle easily. The added bonus of this design also means that the main section stays in the same place. This helps to establish a consistent position to rest your cheek. This is very important. If you are having to remove the whole cheek riser, then every time it will be put back in a slightly different position. This means you will be looking through scope in a slightly different angle and it will effect your shot placement.
Here is some recent customer feedback about our Rifle cheek riser:
“Fast efficient dealer, product is well made and a quick solution to a low stock.”
“A great product. Good communication and fast delivery. Certainly made a difference, the freezers full again!”
“Really happy with the product, would buy again”
Rifle cheek riser specs/features:
- FDM 3D Printed
- Rigid but ultra light weight – 40-67grams!!
- 13/16/18mm height, 137mm Length, 34.5mm width.
- Short term install with supplied tape. Long term install with screw.
- Leave in place while installing/removing bolt and when cleaning.
** rifle, cleaning rod and cheek rest cover not included **
attribution: https://docs.google.com/document/u/3/d/e/2PACX-1vTJvV3V508f_pvNhJprP-8R1c07kbQ158HCWtExxVL4vK3IYnAb68q53wGwBloYZeB-68jM1q-pQLKy/pubSee our other cheek risers for the Ruger 10/22. See Youtube for some of our other products